Installing Molding On Kitchen Cabinets

Installing crown molding on kitchen cabinets takes a whole lot of accuracy and precision in cutting especially the corners.

Installing molding on kitchen cabinets. With these three steps you can install crown molding on your cabinets. This was from an episode of DIY Networks TV show Money Hunters which featured cabine. If you pause the video at 32 you can see the gussets.

The angle cut on the gusset equals the spring angle of the molding. Position the piece of scribe molding along the seam where the back of the cabinet meets the wall. Miter the edge that meets the first strip of crown molding and hold the ends together.

Check out our video REVIEW and DEMO of adding CROWN MOLDING to your KITCHEN CABINETS. For upper cabinets set the cabinet on a cabinet jack. Miter that end of this strip and then attach it to the backing wood with the nail gun.

Httpsbitly2CHOLXK Sweet new drone httpsamznto2SP3VQg The fancy glue I used. Best Online Cabinets shows you a one-minute video on creating light rail molding mounted beneath a top or wall cabinet. The gusset creates an inside corner between the molding and cabinet top.

Place the crown molding so that it is rests upside-down and at a 45-degree angle against the saw fence. You can refer to this video for reference. Mark and cut a piece of scribe molding to match the measurement using a circular saw or a handsaw.

Apply the nail hole filler to fill the nail holes and any gaps at the corners and finally smooth the surface with the 320-grit sanding sponge. Using a sharp pencil with a scribe level the cabinet and then run a pencil against the wall and down the entire length of the cabinet filler. From the sides of the cabinet nail the filler pieces in the place.